© 1999-2007 QualityWaterForLess.com
- 11 -
FIGURE 28 FIGURE 29
•
Connect the other end of this drain line tubing SECURELY to a standpipe or
drain in accordance with all local plumbing codes.
NOTE: Be sure that the
drain line is securely in place before the use of the water softener system.
When the system regenerates, there will be increased flow via this tubing,
which may cause the tubing to become loose.
Programming the Fleck 9100SXT Meter Valve:
•
Before start-up a few simple steps must be followed to program the Fleck
9100SXT Meter Valve.
•
It will be important to know what your water Hardness and Iron is before doing
this programming procedure. If you do not know your water hardness, or if you
are unsure, you may wish to have it tested by sending us a sample for testing, or
by taking a sample to a local pool supply, or hardware store.
•
Your Hardness test results may indicate “Grains”, “PPM”, or “mg/L”. It is
important to note that PPM and mg/L are the same measure and both figures can
be treated interchangeably. If you get a hardness figure in PPM or mg/L, please
divide this number by 17.1 to get Grains.
Ex: If your hardness is measured at
300 PPM, your Grains are 300 / 17.1 = 18 Grains.
•
Your Iron results should be measured in either “PPM” or “mg/L”. Add your level
of iron multiplied by 5. Add this number to your hardness level. This final figure
will be your Total Hardness Level that we will program into your softener system.
•
To begin programming, first plug in your 9100SXT Valve to a nearby wall outlet.
The system will illuminate 4 digits. The system will show the time of day, the
current tank in service, and the amount of gallons remaining. This display will
switch between these valves about every 10 seconds.
•
Access the timer control by loosening the cover thumbscrews as shown in figures
30 and 31 on the following page.
•
Set the time on the system to 12:01 PM by pressing either the “UP” or “DOWN”
arrow as shown in figure 32 on the following page. You may hold the button to
allow the time to scroll faster.
•
Once the time display is set to 12:01 PM, press the “extra cycle” button once as
shown in figure 33 on the following page.
