© 1999-2007 QualityWaterForLess.com
- 8 -
•
Tighten the nut to the Brine Fitting Assembly using until snugly tightened in
place. Be careful not to over tighten, as you may sever the brine line tubing. See
figure 19 below.
FIGURE 19
•
Locate the included brine tank, and remove the brine tank cover shown on the
following page in Figure 20.
•
Next, locate the brine well, and remove the cap as shown in Figure 21 on the
following page.
FIGURE 20 FIGURE 21
•
Pull the 2310 brine float assembly out of the brine well and disassemble the
retaining nut as shown in Figure 22 on the following page.
•
Next, assemble the 2310 brine float assembly to the brine well through the pre-
drilled hole and hand-tighten as shown in figure 23 on the following page.
