Flavor Burst TS 80FCB, Руководство пользователя

Страница: 49 / 77

48
4. Hold a large container under the spout.
Move the draw handle to the open position
to dispense product. Ensure the TS 80FCB
operates properly with all eight syrup lines
dispensing in succession.
NOTE: IF THE SYSTEM SOUNDS A BEEP
AND FLAVORS CEASE TO FLOW, THE
SYSTEM MAY BE SET TO TIMED SERVING
SIZE DRAW MODE. CHANGE THE SYSTEM
TO STANDARD MANUAL DRAW MODE
ACCORDING TO INSTRUCTIONS IN THE
SECTION “SETTING THE STANDARD
MANUAL DRAW MODE” AND THEN REPEAT
THIS SECTION.
5. If a syrup line fails to operate when tested,
select that flavor on the Touchscreen and
draw the serving again to verify the syrup
pump is malfunctioning. See the
Troubleshooting section at
www.flavorburst.com or contact your local
distributor for help.
Disabling the Injector Flush Feature
The Injector Flush function is intended for non-
FCB systems. For the other systems, this
function would flush sanitizer solution through
the spout. In the FCB system, Injector Flush
pushes spurts of air through the line. Since
there is no practical purpose for this key
, it is
recommended the Injector Flush Feature be
disabled on FCB units
to prevent it from
accidently being used, especially in self-service
operations. Follow these directions to disable
the Injector Function.
1. From the main menu screen, press the
SETUP key in the upper left corner. Enter
the password if required.
2. Press the MAINTENANCE key.
3. Press the SETUP OPTIONS key.