Flavor Burst TS 80FCB, Руководство пользователя

Страница: 40 / 77

39
Connecting the Unit Syrup Line
The syrup lines attached at the lower back of
the cabinet connect the eight bags of syrup to
the syrup port of the door spout. The ninth tube
is used during the purge function to shoot a
small blast of air to help clear the syrup port at
the end of the serving.
1. Locate the 9-Tube Lead at the back of the
cabinet. Remove the dust cap and slide the
coupler casing toward the unit to expose the
lead line coupler.
2. Connect the 9-Tube Lead with the 9-Tube
Assembly, with the 9-hole gasket in
between. Align the 9-hole gasket with the
coupler pins of the 9-Tube Lead and place
the gasket against the coupler. Then align
the coupler pins of the two tube assemblies
and connect them.
3. Slide the coupler casing over the connection
and screw each coupler nut into each end of
the casing. Tighten the coupler nuts to
secure the connection.
Installing & Filling the Sanitizer Tank
The Sanitizer Tank system provides approved
sanitizer solution to the Flavor Burst
®
syrup
lines. In order to utilize the clean-in-place
function, keep an adequate supply of approved
sanitizer solution in the Sanitizer Tank at all
times.
The Sanitizer Tank should be checked on a
daily basis, but only needs to be refilled if the
supply is low.
1. Prepare approximately 2 ½ gallons (9.5
Liters) of approved sanitizer solution
according to manufacturer’s instructions.
2. Insert one end of the sanitizer tube into the
fitting located at the lower back of the
cabinet.
3. Insert the other end of the sanitizer tube into
the fitting on the Sanitizer Tank.