Fire-Lite Alarms ES-200X Скачать руководство пользователя страница 57

Страница: 57 / 168

ES-200X Series Manual —

P/N LS10131-000FL-E:C 7/25/2018

Master Programming Level

Programming



Enable zones Z001 and Special Purpose Zone Pre-signal 98 and set the Pre-signal delay timer to some value

With the preceding program settings, when the detector with address 005 is activated, zone Z98 will cause its associated control module
to activate immediately, sounding the connected signaling device to indicate the Pre-signal condition. Following the Pre-signal delay
time, zone Z001 will cause its associated control module to activate and the control panel will initiate an alarm condition.

Note that a detector can be enabled for either PAS or Pre-signal but not both

Zone Assignment

A maximum of five zones can be programmed to each addressable detector. Pressing

while viewing Edit

Detector Screen #4 displays the following screen:

Note that Z*** represents the Zone Number(s) corresponding to this device. The factory default for an unprogrammed device is Z000 for
general alarm zone. A flashing cursor will appear on the first

to the right. Enter the three digit number corresponding to the zone that is

to be assigned to this device. The cursor moves to the next Z*** designation. Continue entering zone assignments or the remaining zones
can be left blank or programmed as general alarm zone Z000. When all desired changes have been made, press the Enter key to store the
zone assignments. The display will return to the Edit Detector Screen #4. Note that the left and right arrow keys can be used to navigate
through the zones and the

CLEAR

key can be used to quickly clear a zone.

If the selected detector is a multi-criteria detector, the following screen will display respective before the Zone Assignment Screen allow-
ing the user to program the zones independently.

Wireless

The Wireless selection will update automatically if the system recognizes a wireless device. A wireless
device operates as part of the SWIFT wireless network. If the detector is wireless, the display reads

Wireless

Yes

. If the device is wired, the display will read

Wireless No

. Fore more information on the SWIFT wireless

network,

refer to the SWIFT manual

, #LS10036-000FL-E.

Sounder Base

The Sounder Base selection allows the programmer to enter different values if the selected detector is mounted in an addressable sounder
base. Pressing

while viewing Edit Detector Screen #5 will display the following:

If the selected detector has been installed in a sounder base, press

while viewing Sounder Base Screen #1 until the display reads

Installed Yes

. Each press of the

key will cause the display to toggle between

Installed Yes

and

Installed No

The Silenceable selection allows the programmer to select whether the selected sounder base can be silenced, either by pressing the
Alarm Silence key or by enabling Autosilence. Pressing the

key while viewing Sounder Base Screen #1 will enable the Silenceable

feature causing the display to read

Silenceable Yes

. Repeated presses of the

key will cause the display to toggle between

Silenceable

Yes

and

Silenceable No

The Coding feature allows the programmer to select the type of output that the sounder base will generate when activated. Pressing

while viewing Sounder Base Screen #1 will cause the following displays to appear:

The programmer can select the sounder base output by pressing the number corresponding to the desired output. The coding selections
are: