19
6. Instruction for Use
6.1 Power On
Powered on scale, it will: -
a. Display software number and revision,
b. Display the calibration count value,
c. Display the parameter set count value,
d. Display all display segments,
e. Scale is now ready for operation.
6.2 Start Weighing
a. If zero weight cannot be obtained when unloaded, press
[Zero]
. After
[Zero]
is pressed, the
Zero Indicator
will appear.
b. Always place an object onto platform gently. Excessive force applied
to platform may cause damages to the weight sensor,
c. The weight of the object is displayed automatically,
d. It is a good practice to remove all loads from platform after weighing. It
will prolong the life of the weight sensor.
6.3 About Weigh Unit Conversion
The default weight unit is = kg. Depends on the internal settings, scale
supports also g and lb.
6.3.1 Conversion between Metric Weight Units (kg and g)
When 3 or 4 decimal places (0.000 or 0.0000) is selected in F80, reading in
g is possible during normal operation by pressing
[Unit]
disregarding to the
setting of
F9
.
The weight unit employed before power off will be employed when powered
on again.
6.3.2 Conversion between Metric (kg and/or g) & Imperial
7
(lb) weight
units (F9)
Scale supports conversion among kg, g and lb. To enable this conversion
7
To comply with the laws of certain countries and approval requirements, the imperial
weight unit may be disabled. Contact your dealer for more information.
