35
The fiber is too thin.
Discharging current strength is too low. Do [electrical machine alignment] maintenance.
[Overlap value] is not sufficient. Adjust the parameter of [overlap value]
Predischarging current strength
is too large.
Reduce predischarging current strength
and the predischarging time.
[Overlap value] is too large. Adjust the parameter of [overlap value]
The fiber is too thick.
The electrical machine hasn’t been alignment Do [electrical alignment] maintenance]
Dust or dirty on the fiber surface
Prepare fiber again.
Axial offset(>0.4um)
The electrical machine hasn’t been alignment.
Prepare the fiber again.
Do [electrical alignment] maintenance].
Dust or dirty on the fiber surface. Prepare the fiber again.
Dirty on the camera lens or
retroreflector.
Clean the camera lens an d
retroreflector, and then check
whether there is dust again.
Set the [clean discharging
time] to 180ms.
Adopt MM mode to splice
the illegible fiber.
Use fiber core alignment method
to splice the illegible fiber.
[Clean discharging time is too short]
Beyond the route of
focusing electrical
machine.
Fiber is mismatching.
Set [clean discharging time]
to 180ms.
Both sides fibers are not belong
to the same type.
Dust or dirty on the camera lens
or retroreflector
Press RESET key and then
correctly place the fiber
Error in optical fiber placing.
Error in optical fiber placing. Press RESET key and then
correctly place the fiber
If continue to splicing may
result in large splice loss,
recommend to use splice mode
that correspondent to fiber.
End face angle is too large.
Beyond the route of alignment
electrical machine.
Magnify the [fiber core limiting value]
to a proper numerical value(standard
angle is 1.0
℃
)
Clean the V groove and the fiber
pressure hammer, and re prepare
them, place the fiber.
[Fiber core angle limiting value]
is too small.
Dust or dirty in the V groove or
on the fiber pressure hammer.
Fiber core angle is too large.
Failure in fiber alignment.
Poor quality of fiber end face.
[Cutting angle limiting value] is
too small.
Prepare the fiber again, i f the
problem can’t be solve, please check
the blade w hether i t has been
abrasion, if so, please turn the blade
to the new side.
Magnify t he [ cutting angle limiting
value] to a proper numerical value.
The fiber is too dirty.
[Clean discharging time] is too short.
Adopt MM mode to splice
the illegible fiber.
Use fiber core alignment method
to splice the illegible fiber.
Clean the camera lens and
retroreflector, and then check
whether there are dusts again.
