16
3.5 Fiber preparation
Four steps should be finished before inserting the fiber to fusion splicer.
2. Sheathe fiber heat-shrinkable tubing
1. Clean the fiber
3. Strip and clean fiber
Coat fiber with heat-shrinkable tubing
3.4.2 Adjust the brightness of LCD backlight
On initial interface, press upper and down key to rapid adjust LCD backlight
brightness until you think it is the most distinct display intensity.
Note: LCD infusion splicer is pin-point device that produced in strict quality control
factory. However, the screen may exist black, red, blue or green dots. Since screen
observation angle is different, the displayer brightness will also be different. This
phenomenon is not flaw of LCD displayer, it is natural phenomena.
Put fiber in the fixture, if ribbon fiber is bent on its tail end about 100mm, please
smooths it.
Fiber fixture is divide into two kinds, respectively are used for left side and right
side, be sure to keep right fixture direction, with label upward.
Open the fixture cover, put number one fiber (generally is blue) near the slide and
retain 30-40mm outside, finally close the fixture cover.
O pen heating strip plier and outermost layer sheath, install fiber fixture to the
designated position, and close heat strip plier and protective layer. Hold fixture and
strip plier tightly, heating it for five seconds, and then smoothly slide to the outside
to remove the coating layer. Use gauze or thin tissue that dipped in alcohol to utterly
clean the fiber. Gauze and tissue cannot be repeatedly use.
Insert fiber
Heat shrinkable
-tubing
Fiber
Use cloth that dipped in alcohol or soft enough tissue to clean the fiber about
100mm from the tail end. If dust on the fiber coating layer enter into inner side of
heat-shrinkable tubing will lead to fiber broken or loss increase.
