3.6.1 Put fiber
17
3.6 Splice operation
4. Cutting fiber
1) Gently hold the press arm of cutting knife and then slide the shackle to unlock
the cutting knife.
2) Propel the slide of cutting knife until it locked.
3) Put the stripped fiber on the cutting knife.
4) Screw down the press arm.
5) Gently loose the press arm, the elastic force will let it back to the initial position.
6) When press arm lift, fiber scrap collector will rotate and automatically roll th e
fiber scrap to debris taper.
7) Completely close the press arm and slide the shackle to lock the cutting knife.
Important: F rom now on t o make sure t he f iber w on’t b e dirty. ( For example,
please not put it on dirty worktable, or swing it on the air). Also you should check
the V-groove whether it is clean, otherwise, you must clean it.
1). Open the wind-proof cover.
2) Open the fiber gland.
3) Put fiber into V-groove and make sure the tail end is locate between V-groove
margin and electrode tip point.
4) Use fiber gland to hold down the fiber.
5) Close wind-proof cover.
Please use high-purity alcohol, more than 99% purity is better.
Surface adhesive force may lead neighbor fiber interlapping; gently flick it to
adjust the fiber.
During clean process, please use your finger to press the fixture cover.
