Appendix B
Error information sheet
34
34
When you use Fusion Splicer
，
error message may appear on the screen
，
please
refer to the solutions that the following table provide
。
If the problems cannot be solved
，
there maybe something wrong with Fusion Splicer
，
please contact the dealer
。
Press RESET key, place the fiber
again to make the fiber end face
lies between electrode center line
and V groove margin.
Error information
Reasons
Solution
The fiber end face beyond the
electrode center line.
Left side fiber lie incorrectly
Right side fiber lie incorrectly
Both end faces contact
Fiber core is too dirty.
[Overlap counts] is set too large.
Adjust the parameter of [overlap
counts].
Electrical machine haven’t been aligned.
Clean the camera lens and retroreflector, and
then check whether there are dusts again.
Make [electrical machine] maintenance.
Dust or dirty on the camera
lens or retroreflector.
Dust or dirty on the fiber surface.
Prepare fiber again.
Impelling electric
machine is wrong
Motor malfunction
Please contact with dealer.
Not discharging
The electrode doesn’t discharging.
Confirm the electrode position;
replace the electrode.
The cladding margin
hasn’t been found.
Error in optical fiber placing.
Fiber end haven’t
been found.
Error in optical fiber placing.
Press RESET key and
then correctly place the
fiber.
Press RESET key and then
correctly place the fiber.
Unidentifiable fiber type
Dust on fiber surface. P
repare fiber again.
Both sides’ fiber types are
different.
AUTO splicing mode can’t
be used, replace the improper
fusion mode.
Beyond the distance of
alignment electrical machine.
Error in optical fiber placing.
Press RESET key and then
correctly place the fiber.
Press RESET key and then
correctly place the fiber.
Fiber margins beyond
the boundaries.
Fiber margins are not within
the camera scope.
Adjust fiber position and do
[electrical machine maintenance].
Dust on fiber surface.
Not correctly in find the fiber
upper and down margins
Prepare fiber again, clean the
camera lens and retroreflector.
Fiber is nonstandard.
AUTO mode can only identif y
standard SM, MM and NZ fiber.
The fiber h aven’t been correctly
placed on the bottom of V groove thus
lead t o fiber skewing beyond t he
formation range of electrical machine.
Beyond the distance
of impelling electric
machine
