Festo — SFAB-...-PNLK — 2022-08
Commissioning
21
7.3.2
Configuring the switching output
The process is basically the same for configuring the switching outputs for OutA and OutB. In the
following, the process is described using the switching output OutA.
Requirement: EDIT mode is active.
1. Press the [Edit] key.
Ä
‘Fctn’ flashes.
2. Select the switching function ‘OFF’, ‘_I¯’, ‘_I¯I_’ or ‘_[]¯’ with the [A] or [B] key.
3. Press the [Edit] key.
Ä
The set value is saved. The next adjustable parameter is shown.
4. Set the parameter with the [A] or [B] key.
5. Repeat steps 3 and 4 until all parameters are set
6. Press the [Edit] key.
Ä
RUN mode is active.
7.3.3
Changing the device settings
Requirement: EDIT mode is active.
1. Select the ‘Spec’ with the [A] or [B] key.
Ä
‘Spec’ is displayed.
2. Press the [Edit] key.
Ä
‘Filt’ / ‘MSEC’ flashes.
3. Set the parameter with the [A] or [B] key.
4. Press the [Edit] key.
Ä
The set value is saved. The next adjustable parameter is shown.
5. Repeat steps 3 and 4 until all parameters are set.
6. Press the [Edit] key.
Ä
RUN mode is active.
7.3.4
Setting the volume pulse output
Requirement: EDIT mode is active.
1. Select ‘Puls’ / ‘VOL’ with the A key or B key.
2. Press the [Edit] key.
Ä
‘SP’ / ‘Volume Unit’ flashes.
3. Set the parameter with the [A] or [B] key.
4. Press the [Edit] key.
Ä
The set value is saved. The next adjustable parameter is shown.
5. Repeat steps 3 and 4 until all parameters are set.
6. Press the [Edit] key.
Ä
RUN mode is active.
7.3.5
Setting the analogue output
Requirement: EDIT mode is active.
1. Select ‘ANLG’ / ‘Out’ with the A key or B key.
