Festo MSE6-E2M, Руководство по эксплуатации

Страница: 36 / 84

36 Festo — MSE6-E2M — 2022-08d
Commissioning
Network-specific LEDs
1)
CPX-specific LEDs
2)
BF Bus error, bus status, red PS Power system, green
PL Power load, green
SF System failure, red
M Modify, yellow
3)
1) The LED BF flashes if there is no network connection.
2) In the standard operating status all green LEDs are on. The yellow and red LEDs are not on.
3) Parameterisation modified or force active.
Tab. 18: LED displays
8.3.2 Connecting to the network
The bus node is connected to the network by a specific connection technology.
Connection technology Network connectors
1 socket, Sub-D, D-coded, 9-pin FBS-SUB-9-GS-DP-B plug
Tab. 19: Overview of connection technology and network plug connectors
Network interface on bus node CPX-M-FB13
Socket, Sub-D PIN IP65 plug
connector PROFIBUS-
DP Designation
1 – Shield Connection to functional earth
2 – n.c. Not connected
3 B R&D/TxD-P Receive/transmit data P
4 – CNTR-P Repeater control signal
5 – DGND Data reference potential (M5V)
6 – VP Supply voltage plus (P5V)
7 – n.c. Not connected
8 A RxD/TxD-N Receive/transmit data N
9 – n.c. Not connected
Housing Clamping
clip Shield Connection to functional earth
Tab. 20: Pin allocation of network interface on the bus node
The bus node is connected to the network at the network interface of the energy efficiency module.
This connection is used for the supply cable and continuing network cable. The Festo FBS-SUB-9-GS-
DP-B plug can be used here.
Connecting the energy efficiency module to the network
Before connecting the Sub-D plug connectors of other manufacturers:
–
Replace both flat screws of the Sub-D plug connector with bolts (type UNC 4-40/M3x5).