Festo CPX-AP-I-PB-M12, Инструкции и эксплуатация

Страница: 12 / 30

AP parameter
ID Parameter Instance-
s Data
type Access
1)
Arraysize
246 Fieldbus serial number 1 UINT32 ro
–
791 Product key 1 CHAR ro 12
960 Firmware version 1 CHAR ro 40
20000 Module code 1 UINT32 ro
–
20085 Measured value temperature AP-ASIC [°C] 1 INT16 ro
–
20087 Current measured value of logic supply PS
[mV] 1 UINT16 ro
–
20088 Current measured value of load supply PL
[mV] 1 UINT16 ro
–
20093 Hardware version 1 UINT8 ro
–
1) ro = read only; rw = read write
Tab. 14 AP parameter
10 Diagnostics and fault clearance
10.1 Diagnostics options
Diagnostics via LED displays
The system and network status and errors are displayed directly on the module via LED indicators
è
10.3 LED displays.
Diagnostics via PROFIBUS
Diagnostics as part of the PROFIBUS functions (DPV1) via control software over the network
è 10.4 Diagnostics via PROFIBUS.
10.2 Diagnostic messages
Only the diagnostic messages of the interface are listed in the following table.
Module-specific diagnostic messages
è Instructions for the applicable module
Information on grouping and displaying the diagnostic messages è Instruction manual for the auto-
mation system CPX-AP.
ID hex (dec) Message Description
Overvoltage of the logic supply PS 24 V DC was detected.
Remedy – Check logic supply PS.
02
|
01
|
0017
(33619991)
Overvoltage in logic
supply PS 24 V DC
Diagnost-
ic status Error
Diagnostics and fault clearance
12 Festo — CPX-AP-I-PB-M12 — 2020-03