Festo CPX-AP-I-PB-M12, Инструкции и эксплуатация

Страница: 17 / 30

10.4 Diagnostics via PROFIBUS
The automation system CPX-AP supports the following diagnostic options via PROFIBUS DP in accord-
ance with IEC 61158.
DPV1
– Station status (standard diagnostics)
– Device-related diagnostics (alarm messages)
– Identifier-related diagnostics (diagnostics assigned to the modules)
– Channel-related diagnostics (diagnostics assigned to the channels)
–
Module number
– Channel number and input/output
– Type of diagnostics (error type/channel type)
The diagnostic information is sent to the master system only when the diagnostic mode is activated.
10.4.1 Overview of diagnostic bytes
Station status (6 bytes)
Byte Contents Explanation
1 Station status 1
è
Tab. 23 Station status 1
2 Station status 2
è
Tab. 24 Station status 2
3 Station status 3
è
Tab. 25 Station status 3
4 Diag.Master_add Address of the master after parameterisation (factory setting
255).
5 Ident_number
(high byte) Manufacturer ID 0x11 (high byte)
6 Ident_number
(low byte) Manufacturer ID 0x42 (low byte)
Tab. 17 Station status (6 bytes)
Diagnostics and fault clearance
17 Festo — CPX-AP-I-PB-M12 — 2020-03