Ferrari Portofino, Руководство пользователя

Страница: 174 / 208

174
ADVICE FOR EMERGENCY SITUATIONS
To cut off the power supply from the battery to the electrical system,
use the quick release
C on the left side of the battery. Use the locking
lever to loosen the terminal.
Detach the terminal from the battery: the power supply from the battery
to the electrical system is cut off.
Warning
The battery quick release must only be used if the battery conditioner
cannot be connected.
Warning
Place the terminal so that it does not come into contact with the
battery terminal or other metal parts of the vehicle.
Reconnecting the battery
Place the clamp on the battery and fasten it by closing the locking lever.
Each time the battery is reconnected, do the following before starting the
engine:
●
close both doors and close the luggage compartment lid; unlock
and lock the doors using the remote control; open the luggage
compartment lid using the remote control.
●
adjust the clock (date and time on instrument panel);
●
close both doors and fully raise the driver side and passenger side
windows to their upper limit; check that the windows move down to
the “target position” when the doors are opened.
Warning
Before starting the engine, wait at least 60 seconds after activating
the instrument panel to allow the electronic system that controls the
motor-driven valves and the AC ECU to run a self-acquisition process.
During this period, no devices must be activated.
The Motronic ECU self-acquisition cycle will only function correctly when
the intake air temperature is above 5
°
C.
After removing the battery from the vehicle or disconnecting it from
the electrical system using the battery master switch, it is important to
check that the external temperature is within the indicated values when
reconnecting before performing the self-acquisition cycle.
Emergency starting
If the battery is flat, you can perform an emergency start by connecting
the special jump leads to the battery of another vehicle, a portable jump
starter or an external battery.
Important note
Emergency starting can only be performed with batteries with a
nominal voltage of 12 V.