Ferrari Portofino, Руководство пользователя

Страница: 123 / 208

3
ABOUT YOUR VEHICLE
123
Important note
Hold the brake pedal down while starting the engine.
●
ENGINE STOP , to switch off the engine when the vehicle is
stationary, press the ENGINE START/STOP button on the
steering wheel.
If the vehicle is in motion and the engine has to be switched off in an
emergency situation, press the ENGINE START/STOP button and hold
it down for at least 2 seconds (alternatively, press the button quickly 3
times in succession). If the key battery has a charge level that is only just
sufficient, the vehicle informs the driver via a message on the left TFT
display of the instrument panel and recommends replacing the battery as
soon as possible. If the battery is flat or the key is not recognised, perform
the emergency switching off procedure (see page 158).
Warning
If the door closing button on the key is pressed when inside the vehicle,
the engine start function is disabled. The door opening command must
be given to deactivate the alarm and, in this way, the engine can be
restarted. This occurs even if the door closing command is given by a
key outside the vehicle when a second key is inside. The engine start
function of the second key (inside the vehicle) will be disabled. By
issuing the door opening command on any registered key, the engine
start function is reset.
If the engine fails to start after several attempts, check for one of the
following causes: insufficient starter motor speed (flat battery), faulty
ignition device, faulty electrical contacts, fuel pump fuses blown.
Warming up the engine
Do not run the engine at high speed until the engine oil temperature has
reached at least 65-70
°
C, approximately.
R
Starting the vehicle
With the engine started, the vehicle stationary and the brake pedal
pressed, pull the right-hand
UP paddle towards the steering wheel to
engage 1st gear.
Release the brake pedal and press the accelerator to start off.
With the engine running and the vehicle stationary, you can change
directly from
1st or 2nd gear to “ R ” (reverse) by pressing R on the centre
console and from reverse to 1st by moving the UP paddle.
Warning
If the “UP” and “DOWN” paddles are not working, the message
“Depress brake pedal and press LAUNCH to engage gear” will appear
on the left TFT display; you can therefore engage the gear by pressing
the LAUNCH button on the centre console and the brake pedal. In
these cases, the “Launch Control” function is not available. If the
engaged gear was R, the LAUNCH button must be pressed twice to
engage 1st gear.