EN
11
ATTENTION: Never hold the pieces to be cut in
your hand.
When the pieces to be cut are profi led sections, fl at pieces
or special shapes, refer to the examples shown in the
fi gures.
If the thickness of the profi led section is to be very thin,
an outline should be fi tted which copies the profi le inside
the profi led section itself to stop it being crushed between
the jaws.
4.6 CUTTING
TABLE
Two speed version
MATERIAL: ............ M42 (acciaio per molle + acciaio HSS)
EXTENSION : .......................................................mm 1330
HEIGHT: ....................................................................mm 13
THICKNESS:..........................................................mm 0,65
TOOTHING: ...................................................standard 8/12
....................................................................optional 6-14-18
6 MAINTENANCE
6.1
REGULAR MAINTENANCE
The operations of ordinary maintenance, which may also be
performed by non-specialist personnel, are all described in
the previous sections and here below.
1. Before performing any maintenance operation, disconnect
the machine electric plug from the wall outlet.
2. During maintenance operations, always wear personal
protection (safety goggles and gloves).
3. Remove the processing residues from the cutting
area and the blade guides whenever necessary.
You are advised to use a suction device or a brush.
ATTENTION: Do not use jets of compressed air.
4. If you do not intend to use the sawing machine for a
long time, clean it and put it in a dry place if possible.
In these cases it is advisable to slacken off the blade so
that it is not kept tight for no reason.
6.2 ASSISTENCE
Should it be necessary to call qualified personnel for
operations of extraordinary maintenance, or in the case of
repairs, under guarantee or at a later date, you should always
contact an authorized service centre or the factory directly, if
there is no service centre in your area.
6.3
DISPOSAL OF THE MACHINE AND ACKAGING
INFORMATION FOR USERS
In accordance with art. 13 of Legislative Decree
25th July 2005, no. 151 “Implementation
of Directives 2002/95/EEC, 2002/96/EEC
and 2003/108/EEC, relative to reducing the
use of hazardous substances in electrical and electronic
appliances and the disposal of waste”, please take note of
the following:
• The crossed out wheelie bin symbol found on the
appliance or on the packaging, indicates that the product
must be disposed of separately from ordinary household
waste when it reaches the end of its working life.
• The user must consign the unwanted appliance to
an authorized differentiated waste disposal centre for
electrical and electronic goods, or alternatively, hand it
over to the relative dealer on purchasing a new appliance
of the same type on the basis of a one to one ratio.
4.5
CORRECT POSITIONING OF THE PIECE IN THE
CLAMP
The pieces to be cut should be fi tted directly between the
jaws without adding other objects.
5
ACCESSORIES
5.1
CHOISE OF BLADE
Your sawing machine is equipped with a bi-metal blade
measuring 1330x13x0.65 mm with variable toothing, for use
in the majority of cuts possible with this machine.
For special requirements (see cutting table point 4.6), for
example, for cutting large solid sections or profi led sections
or corner pieces of small thickness, there are also blades
avail-able with 6, 14 or 18 teeth per inch.
Electronic version
