OBID i-scan
®
System-Manual
ID ISC.MR/PR/PRH101
FEIG ELECTRONIC GmbH
Page 25 of 131
H60301-3e-ID-B.doc
3.3. CFG2: Inputs / Outputs general
Via the following parameters the operation mode of the LED and the buzzer (only ID ISC.PRH101) can
be configured at any time. One byte each is reserved for the active and mute position, by means of
which the individual operation modes according to the schedule below may be adjusted. In addition to
this, for the active- and mute position different flashing frequencies of the LED and intervals of the
buzzer may be defined. So, the LED may be used as an operation indicator.
Byte
0
1
2
3
4
5
6
Contents
0x00
0x00
0x00
IDLE-STATE
IDLE-FLASH
0x00
0x00
Default
0xA9
0x00
Byte
7
8
9
10
11
12
13
Contents
ACTIV-
STATE
ACTIV-
FLASH
ACTIV-
GRN-TIME
ACTIV-
RED-TIME
ACTIV-
BUZZER-
TIME
0x00
0x00
Default
MR/PR: 0x26
PRH: 0x96
0x00
0x0A
0x0A
MR/PR: 0x00
PRH: 0x05
1 sec.
1 sec.
1 sec.
USB-Ver-
sion
MR/PR: 0x26
PRH: 0x96
MR/PR: 0x00
PRH: 0x05
Note:
•
The Readers dispose of a two colored LED (red / green). The color orange can be obtained
by combining both basic colors red and green.
Colors ID ISCMR / PR:
LED
Color:
red
green
red
1
0
green
0
1
orange
1
1
•
The buzzer is only with the ID ISC.PRH101 available.
IDLE-STATE / ACTIVE-STATE
One byte each for idle- and tag-detect state is used to set the operation mode of the signal
transmitter.
Bit:
7
6
5
4
3
2
1
0
Function:
Startup
Buzzer/
LED
0
BUZZER
RED
(PRH: BLUE)
GRN