MTM Hydro Inc.
Components and accessories for high pressure cleaners and car wash
7430 Washington Ave So. - Eden Prairie Minnesota 55344
phone 952.746.4825 - 866.MTM.4020 - fax 952.746.4829 - 866.MTM.4021
www.mtmhydro.com - [email protected]
PROFESSIONAL FOAM LANCE - USERS MANUAL
Product’s Use
Service
A pressure washer with a minimum of 1.8 GPM flow and 1,100 PSI is required for the product to operate correctly.
Use fresh clear water, with common detergents. We recommend that any impure fluid be adequately filtered before it is
used. Detergents with suspended particles can clog the filter and the product will fail to operate properly.
MTM Hydro, Inc. does not manufacture or supply any of the chemicals used with our product and is not responsible for
their effects. Because of the large number of chemicals that could be used (and their different chemical reactions), the
buyer and user of this equipment should determine compatibility of the materials used and any of the potential hazards
involved.
NOTE: Always remember to carefully read the chemical manufacturer’s label and follow all directions.
**** AFTER EVERY USAGE PRIOR TO STORAGE, RINSE AND THOROUGHLY FLUSH WITH CLEAR WATER.
FAILURE TO THOROUGHLY RINSE AND FLUSH CHEMICALS WILL CAUSE THE FILTER TO CLOG AND THE
PRODUCT WILL FAIL TO OPERATE PROPERLY. THIS FAILURE CAN OCCUR AFTER THE FIRST USE. ****
1.Remove 1 litre bottle
2.Pull trigger on spray gun
3.Allow clean clear water to thoroughly flush out chemicals in filter for a few minutes
WARNING: Check to ensure that the product is compatible with the system’s operating specifications do not
exceed the maximum flow, pressure, and temperature ratings of the product that are listed in this manual (see
Technical Chart).
Installation must be done exclusively by skilled workers. The Manufacturer is not responsible or liable for any
loss or damage arising from improper installation or installation done by unskilled workers.
Service must be done exclusively by skilled workers using only original MTM Hydro replacement parts.
To correctly reassemble, follow the drawing listed in the exploded view in this manual.
WARNING:
The components need to be properly reassembled to restore the original conditions of the product.
The
Manufacturer is not responsible or liable for any loss or damage arising from improper reassembly or service
by unskilled workers.
The Professional Foam Lance combines a high pressure water flow mixed with detergent and air to produce thick
clinging foam. With the adjustable intake you can increase or decrease the amount of detergent drawn into the water
flow adjusting the amount of foam created. Furthermore, the professional foam lance has a variable angle spray pat
-
tern that with a simple twist goes from a 0 degree focused jet to 50 degree fan pattern.
Page 1 of 1
To correctly install, use, and service this product, carefully read and follow the instructions and warnings contained in
this manual. Ensure these instructions are included in the final user’s manual of any machine in which the product is
assembled.
Any improper use of or alteration of this product may cause loss or injury. The Manufacturer is not responsible
or liable for any loss, damage, or injury arising from improper use or alteration and declines all liability for its
functioning and safety.
The product described here complies with the rules and the lines in force that you can find in the MTM Hydro, Inc.
CONFORMITY DECLARATION.
MTM Hydro declines all responsibility and liability in the case that the compliance and regulations stated in this manual
are not followed or respected.
MTM Hydro reserves the right to make any modification to both products and manuals without notice.
Further Instructions
