Federal Signal Corporation UltraVoice UVIC, Описание, Технические характеристики, Установка, Эксплуатация и Руководство по обслуживанию

Страница: 57 / 70

57
Operations
Description, Specifications, Installation, Operation, and Service Manual
AC Power/Solar (JP15: pins 7 and 8)
Jumper JP15 pins 7 and 8 when using solar only. If using ac, 7 and 8 are connected to ac
power sensor.
600 ohm PTT (JP15: pins 9 and 10)
Shorting pins 9 and 10 puts the UV+ controller card in local PA mode.
User-Defined Application (JP15: pins 11 and 12)
Use spare JP15: pins 11 and 12 for user-defined application.
+5 Vdc Supply (JP16)
The UVC backplane motherboard can 5 Vdc for external use up to 150 mA.
Table 43 External Sensors
JP16 Terminal Function
1—(-) Isolated Supply (ground)
2—(+) Isolated Supply (+5 V)
Spare Sensor Inputs (JP17)
The inputs at JP17 are not used in typical applications with the UVIC controller.
Two-Way Sensor Package
The two-way sensor package uses a variety of sensors in the UVIC controller, which
when equipped with a two-way radio allows the remote units to communicate its status
back to the base station. This reduces station down time by quickly alerting operating
personnel to potential problems at remote units.
The package itself consist of sensors to provide information on the following conditions:
• AC Power
• Battery Voltage (built in)
• Charger Operation (built in)
• Activation Current (built in)
• Signal A (built in)
• Signal B (built in)
• Quiet Test (amplifiers and drivers built in)
• Intrusion
All sensors are optically coupled to provide protection in electrical interface conditions.
Consult Federal Signal for further information.