Federal Signal Corporation UltraVoice UVIC, Описание, Технические характеристики, Установка, Эксплуатация и Руководство по обслуживанию

Страница: 32 / 70

32
Installation
UltraVoice Indoor Controller (UVIC)
Contact Closure Inputs (JP14)
Connect any desired remote contact closure inputs to the remote control inputs at JP14 on
the Motherboard. See Specifications and Operations sections for further information on
JP14.
Optional UVARM Connections
Connections to the UVARM are made on the front of the UVARM card located between
the Control module and the Amplifiers. All connections for the UVARM are labeled on
the front the card. Tie wrap the UVARM wiring to the bottom of the card cage assembly
and route through the plastic wiring raceway. See General Description for a description
of the UVARM connection points and Installation Instructions for Antennas at the Federal
Signal’s website for connection details.
Optional UVLOC Connections and Wall Mounting
See “Figure 6 UVLOC Dimensional Outline” and “Figure 7 UVLOC Interface Wiring
Diagram” for the UVLOC mounting hole locations. The UVLOC is typically mounted on
a wall approximately 5 feet above the ground.
The UVLOC requires a CAT5 cable between the UVLOC and the interface board
(UVLOC-IM) in the UVIC. One to one connections are made with either the RJ45
terminations or a bare wire terminal block at each end. The interface board connects to
the UVIC motherboard using interface cable as shown in “Figure 7 UVLOC Interface
Wiring Diagram”
The UVLOC-IM mounting bracket attaches to the left side of the control cabinet using
two of the charger mounting studs and the intrusion switch mounting studs. See “Figure
21 UVIC Final Assembly and Parts List” on page 70 to view the UVLOC-IM bracket
and PCB mounting detail.
Label the UVLOC to ensure the operators know what messages and functions are
available. Verify the UVLOC is labeled properly for the application.