Federal Signal Corporation UltraVoice UVIC, Описание, Технические характеристики, Установка, Эксплуатация и Руководство по обслуживанию

Страница: 11 / 70

11
General Description
Description, Specifications, Installation, Operation, and Service Manual
General Description
Introduction
This manual describes the features, specifications, installation, operation, and
maintenance of the UltraVoice
®
Indoor Controller (UVIC). The UVIC is designed
to deliver amplified audio to a network of speakers (sold separately), and configured
for indoor notification or evacuation. The UVIC has been designed for high-quality
reproduction of live or pre-recorded voice and tone that provides the ability to automate
testing and emergencies.
The UVIC is housed in a single NEMA1 style cabinet. The UVIC uses one amplifier card
for a 400-Watt system and two amplifiers cards for an 800-Watt system. All siren control,
audio generation, and remote communication functions are handled by a single UV+
controller board. The backplane motherboard contains connectors and terminal blocks
for interconnection of the other system components. Power is supplied by two 12-volt
batteries that are charged from the 24 Vdc battery charger.
All UVIC models are setup for two-way control and status monitoring using the
Commander
®
Software System (Commander) including a nominal 12 V radio power
supply and antenna lightning protector. All models can be equipped with a micro memory
SD card to store up to 17 hours of tone or digital voice messages. Custom digital voice
recording requires a model DVR.
Activation codes, command sequences, and operating parameters are uploaded from a
computer through the RS232 port located on the front panel or over the radio channel
with Commander. All user information is stored in non-volatile FLASH memory, immune
to power and battery failure.
The UVIC can be activated by landline, radio or IP from a remote location. Landline
activation can initiate one of the eight on-board functions by connecting a momentary
dry contact closure (customer supplied) to the appropriate PC board mounted terminal
block. These functions can contain a combination of tone and prerecorded voice or Public
Address. Public Address is available from the supplied microphone located inside the
controller.
Features
The UVIC controller has the following features.
• Seven standard warning signals: wail, alternate wail, pulsed wail, steady, alternate
steady, pulsed steady, and Westminster chime (auxiliary).
• Optional micro SD card for custom message storage. Store up to 4,093 voice or tone
messages that total up to 17 hours of total recording time.
• Use local pushbuttons (eight) on controller card for testing or local siren activation.
• Ability to interface with up to eight externally wired pushbuttons for siren activation.
• Local microphone for live public address (PA) with internal mount.
• Single tone, Two-tone, DTMF, EAS and MSK decoders for remote siren control.