19
Installation and Maintenance Manual
Federal Signal
www.fedsig.com
Mounting the IPX600 Light Head to a Vehicle
DRILLING PRECAUTIONS: When drilling holes, check the area
you are drilling into to ensure that you do not damage vehicle
components while drilling. All drilled holes should be de-burred,
and all sharp edges should be smoothed. All wire routings going
through drilled holes should be protected by a grommet or
convolute/split loom tubing.
4.
Use a #21 drill bit to drill two 0.159-inch holes at the scribed
mounting hole locations.
5.
Drill a 3/4-inch hole at the wire-routing location.
6.
Prepare the hole for the wires by removing all burrs and
sharp edges.
7.
Route the cable from the light head through the holes in the
gasket and mounting surface (Figure 1). Use grommets, wire
ties, looms, and cable mounts (not supplied) as needed to
secure and protect the wiring.
Figure 1 IPX600 mounted with bezel
Bezel
Gasket
#10 Type B Screw (2)
WARNING
!
Will ca
use ey
e dam
age.
- Do n
ot stare
into lig
ht bea
m.
- Do n
ot view
at clo
se ran
ge,
Hot su
rface, c
an cau
se burn
s.
- Do n
ot touc
h.
- Allow
unit to
cool b
efore h
andlin
g.
8.
Place the mounting bezel over the light head and secure
it to the mounting surface with the #10 sheet-metal screws
provided.
