16
IMPAXX
®
IPX600 Series LED Light Heads
Federal Signal
www.fedsig.com
Configuring Multicolor Light Heads
To set the white LEDs to always flash:
1.
Connect the black wire from the light head to ground
(–GND).
2.
Apply 12 Vdc (+BAT) to the red wire from the light head.
3.
Hold the green pattern-selection wire to ground (–GND)
until the light head goes out and then flashes four times.
This procedure takes approximately 6 seconds. Remove the
green wire from –GND, shortly after the four flashes complete.
Changing from follower to controller resets all features to
default. See Table 2 on page 14 for defaults. The light head
has now been placed into Pattern Number 2, which is 79 FPM
Power Quad.
4.
Repeat the above procedure to disable white LEDs from
always flashing with the pattern
If the OPTION wire is set for steady burn and there is more than
one color in a light head, you can change which color steady
burns when the OPTION wire is active.
Setting the Steady-Burn Color
To change the steady-burn color:
1.
Connect the black wire from the light head to ground
(–GND).
2.
Apply 12 Vdc (+BAT) to the red wire from the light head.
3.
Set the light head to be controller or follower. See
"Converting a Light Head from Controller to Follower and
Vice Versa" on page 13.
4.
Apply 12 Vdc (+BAT) to the white wire from the light head.
5.
Hold the green pattern-selection wire to ground (–GND)
until the light head goes out and then flashes three times.
This procedure takes approximately 3 seconds. Remove
the green wire from –GND shortly after the three flashes
complete. The selected steady burn color will flash three
times.
