17
Installation and Maintenance Manual
Federal Signal
www.fedsig.com
Mounting the IPX600 Light Head to a Vehicle
Setting a Multicolor Light Head to Flash One Color
To change the from multicolor to one color:
1.
Connect the black wire from the light head to ground
(–GND).
2.
Apply 12 Vdc (+BAT) to the red wire from the light head.
3.
Hold the green pattern-selection wire to ground (–GND)
until the light head goes out and then flashes five times. This
procedure takes approximately 15 seconds. Remove the green
wire from –GND, shortly after the five flashes complete. The
multicolor light head now flashes one color.
Changing the Follower Power-Up Color
To change the power-up color for a follower:
1.
Connect the black wire from the light head to ground
(–GND).
2.
Apply 12 Vdc (+BAT) to the red wire from the light head.
3.
Set the light head to be a follower. See "Converting a Light
Head from Controller to Follower" on page 13.
4.
Tap and remove the green pattern-selection wire from the
controller light head to ground (–GND) to display the color
you want on power up. The light head will flash three times
in the color in which it will power up.
