FCI 7100 SERIES, Инструкция по установке и эксплуатации

Страница: 24 / 47

No. of LCD-7100 units 1 2 3 4 5
Max resistance of 24 VDC power
circuit (ohms) to most distant LCD
70 38 24 17 4
3.14 Digital Communicator
Before connecting the 7100-D to the public switched telephone network the installation of two (2) lines
is necessary. The following information is provided if required by the local telephone company:
Manufacturer:
Fire Control Instruments, Inc.
302 2nd Ave.
Waltham, MA 02451-1133
Product Model Number: 7100-D
FCC Registration Number: 6KWUSA-34215-AL-T
Ringer Equivalence: 0.5B
3.15 Telephone Company Rights and Warnings
The telephone company, under certain circumstances, may temporarily discontinue services and/or make
changes in its facilities, services, equipment or procedures which may affect the operation of this digital
communicator. However, the telephone company is required to give advance notice of such changes or interrup-
tions. If the digital communicator causes harm to the telephone network the telephone company reserves the
right to temporarily discontinue service. Advance notification will be provided except in cases when advance
notice is not practical. In such cases, notification will be provided as soon as possible. The opportunity will be
given to correct any problems and to file a complaint.
DO NOT CONNECT THIS PRODUCT TO COIN TELEPHONE, GROUND START OR PARTY LINE
SERVICES.
•
When the digital communicator activates, premise phones will be disconnected.
•
Two separate phone lines are required. Do not connect both telephone interfaces to the same telephone
line.
•
The digital communicator must be connected to the public switched telephone network upstream of any
private telephone system at the protected premises.
•
This equipment is designed to be connected to the telephone network or premises wiring via terminal
blocks.
3.16 FCC Required Information
This equipment complies with Part 68 of the FCC Rules. The Ringer Equivalence Number (REN) is listed in
Section 3.13, while the FCC Registration Number is listed in 3.14. These numbers must be provided to the
telephone company, if requested.
3.17 Repairs
The 7100-D Digital Communicator does not contain any user-serviceable parts. The unit must be returned to
the factory for repair through an authorized FCI distributor.
3.18 Optional Accessories
3.18.1 LCD-7100 Serial Remote Annunciator
The LCD-7100 Serial Remote Annunciator provides an 80-character display and function keys for “Alarm
Acknowledge”, “Trouble Acknowledge”, “Signal Silence”, “System Reset/Lamp Test” and “System Drill Test”. The
80-character display shows all pertinent information except for menus.
Keypad functions are enabled only when the keylock is turned to the “Unlocked” position, with the exception
of the “Trouble Acknowledge” switch which silences the local audible trouble sounder.
LEDs provided are “Alarm”, “Supervisory”, “System Trouble”, “Power Fault”, “System Silenced”, “NAC #1
Silenced” and “NAC #2 Silenced”.
The LCD-7100 is flush or surface mounted on a standard three-gang electrical box.
The 7100 Series control can accommodate up to five (5) remote LCD-7100 annunciators which may be
located up to 4,000 feet away from the main control panel. See the chart below for resistance limitations of the
connecting circuit.
22 of 43 9000-0447
Technical Manuals Online! - http://www.tech-man.com