FCI 7100 SERIES Скачать руководство пользователя страница 20

Страница: 20 / 47

3.5 Analog Sensors

The 7100 accommodates only FCI approved, U.L. Listed, Factory Mutual Approved analog sensors and

bases. See FCI Publication, P/N 9000-0427 for a list of approved sensors and bases. Each signaling line circuit
can accommodate 99 sensor address points, using Address numbers 01 to 99.

3.5.1 Address Switches

Addresses are set via the rotary switches on each sensor or module. Setting the address is accomplished

by turning each of the two (2) rotary switches until they point to the numbers indicating the proper address (e.g.,
SW1 @ #2 and SW2 @ #5 would indicate address #25).

3.5.2 Drift Compensation

The 7100 contains a program which performs continuous testing of analog sensors, including sensitivity tests.

This program will compensate all analog sensors for age and environmental conditions. Should a problem occur
in a sensor, a “Failed Test”, “Dirty” or “Very Dirty” indication for the specific device will appear on the system
display and be recorded in the Event Log and the Serial Port.

3.6 Addressable Modules

The 7100 accommodates only FCI approved, U.L. Listed, Factory Mutual Approved addressable modules.

See FCI Publication, P/N 9000-0427 for a list of approved modules. Each SLC can accommodate 98 address-
able module points, using Addresses 101 through 198.

The modules that occupy this address range consist of Monitor (input) modules and Control (output) modules.

3.6.1 Address Switches

These addresses are set via the rotary switches on each module. Setting the address is accomplished by

turning each of the two (2) rotary switches until they point to the numbers indicating the proper address (e.g.,
SW1 @ #5 and SW2 @ #7 would indicate address # 157). Note that the “100" digit is pre-set in all addressable
modules.

3.7 Monitoring Modules

The 7100 accommodates only FCI approved, U.L. Listed, Factory Mutual Approved addressable monitor

modules. Dry contact devices and two wire smoke detectors can be monitored by these modules, which act
as the interface between the manual station, waterflow switch, etc. and the control panel.

See FCI Publication, P/N 9000-0427 for a list of approved modules.

3.8 Control Modules

The 7100 accommodates only FCI approved, U.L. Listed, Factory Mutual Approved addressable output

modules on its SLCs. See FCI Publication, P/N 9000-0427 for a list of approved modules.

Notification appliances, relays and circuits using compatible voltages (through an internal dry contact) can be

controlled by these modules.

3.9 Optional Modules

3.9.1 Class A Option Module (CAOM)

The CAOM provides Class A signaling for the notification appliance circuits and Class A, Style 6 signaling

for the signaling line circuits. It also provides a disconnect switch for each signaling line circuit and a common
disconnect switch for both notification appliance circuits. See Table 3 for wiring connections.

3.9.2 Municipal Circuit Option Module (MCOM)

The MCOM provides output for a Local Energy City Master Box, reverse polarity output for leased line

connection, or releasing solenoid output. See Table 3 for wiring connections and FCI Publication, P/N 9000-
0427 for a list of approved solenoids.

Ratings:

Master box (NPL)

Polarity Reversal (PL) Releasing Service (NPL)

Nominal voltage

24 VDC

Supervisory current

.0018 amp.

.012 amp.

.0005 amp.