FCI Watermakers DOCKSIDE TREATMENT SYSTEM PLUS Series, Руководство пользователя и инструкция по установке

Страница: 34 / 80

FCI WATERMAKERS, INC. 34 Installation
INSTALLING THE PLUMBING
Table 2
lists the all the plumbing connections by letter, and Figure
14 shows the connections on the components. Work through each
tube or hose in the table, one-at-a-time until complete.
1. Identify the tubing or hose by its specifications in the table's description column.
Refer to "COMPONENT DESCRIPTIONS" on
page 20
if you need review.
2. Identify where the two ends connect. Use the "General Connection
Diagram" on page 31 and Figure 14 on page 35.
3. Cut the tubing or hose to length, install fittings the ends, and connect to
the system component. The fittings are on the system or supplied with the
installation kit. For PVC helix wire suction hose, use the barbs and clamps.
Table 2: Hose, Tubing, Route & Description
Item From To Description
Hose A Dockwater Source Filter Assembly Inlet 3/4 inch PVC Helix Wire Suction Hose
Tube B Filter Assembly Outlet Panel, "Feed from Filters"
1/2 inch PE Tubing
NOTE: Required only if replacing pre‑configured tube
for modular mount; you may reuse its connectors.
Tube C Panel, "To Vessels" Vessels, Flow In 3/8 inch 250 psi PE Tubing
Tube D Vessels, Reject Out Panel, "From Vessels" 3/8 inch 250 psi PE Tubing
Tube E Vessels, Product Out Panel, "Product Inlet" 3/8 inch 125 psi PE Tubing
Tube F Panel, "Reject Discharge"
Reject Discharge Fitting,
Above Sea Level
1/2 inch PE Tubing
NOTE: Use with 1/2 inch connector from Install Kit.
Tube G Panel, "Product to Tank" Product Water Tank
3/8 inch 125 psi PE Tubing
NOTE: Use with 3/8 inch connector from Install Kit.
SYSTEM INSTALLATION / PLUMBING
(continued)
Read the overview on this page and study the illustrations on the
following page. Make the plumbing connections when ready.