FCI Watermakers DOCKSIDE TREATMENT SYSTEM PLUS Series, Руководство пользователя и инструкция по установке

Страница: 26 / 80

FCI WATERMAKERS, INC. 26 Installation
COMPONENTS SUPPLIED BY INSTALLER
Most of what you will need to install your system is included in
your package. As each system installation varies, not all installation
fittings, hose and tubing can be provided. There are a few items
that you will need to consider for your individual system.
Select a suitable location for the components and evaluate where you plan
to place them. Obtain a good working estimate as to the footage of hose
that will be needed and contact your dealer or FCI for the supplies.
Table 1
summarizes the specifications for components supplied by installer.
CAUTION
: All fittings, valves, and piping installed prior to, within, and after
the system must not contain iron. If the resulting failure of the R.O. membrane
element is attributed to improper installation, it is the liability of the installer.
Table 1: Specifications for Components Supplied by Installer
Connection Specification
Dockwater source The FCI Watermakers System must
receive an uninterrupted supply of feed
water (50 psi maximum) without air
Connection at dockwater source 3/4" hose barb
Reject discharge 1/2" minimum at or above water level
Connection at reject discharge 1/2” NPT
Connection to dockside unpressurized
potable water storage tank
NOTE
: In order to avoid problems such
as reverse flow from the tank to the
system and chlorination attack of the
R.O. membrane element, the fitting must
terminate above the maximum water level.
WARNING
: No valves should be installed
in this line. A blockage or closed valve in the
product water line will cause extensive damage
to the system and R.O. membrane element.
3/8” NPT
Incoming Power 120 VAC / 240 VAC, 50/60 Hz
Current Draw (Actual current draw will
vary with incoming power conditions)
5.7 A @ 120 VAC
2.9 A @ 240 VAC