FCI Watermakers DOCKSIDE TREATMENT SYSTEM PLUS Series, Руководство пользователя и инструкция по установке

Страница: 4 / 80

FCI WATERMAKERS, INC. 4 General
PREFACE
We are committed to customer service that exceeds your expectations. If at any
time you have questions about what’s covered in this manual, our hands-on
technical support will never leave you adrift. This manual contains technical
information & instructions for the installation, operation, maintenance, and
troubleshooting for FCI Watermakers Desalination Systems. Anyone responsible
for the installation, operation, and maintenance of a FCI Watermakers Desalination
System must read and understand the contents of this manual, and comply
with these instructions, guidelines, and safety requirements at all times.
The term system will be used throughout this manual, and it generally refers to
the FCI Watermakers DTS
+SOLO
. Reading this manual in its entirety will familiarize
you with the system and the operation of its components. By understanding
the system in its entirety, one can readily operate and diagnose problems.
All references within this manual refers to other sections unless specifically
defined. Graphics and illustrations are used for reference only and may not
represent the actual part or arrangement of parts in a customized system.
ABOUT SAFETY NOTES
Safety issues requiring users attention are highlighted throughout this manual as follows:
WARNING:
Provides critical information in order to
prevent the possibility of injuries and/or death.
CAUTION:
Provides important information to prevent the
possibility of damaging the device or equipment.
NOTE:
Provides additional information to safely
and properly operate the equipment.
NEW SYSTEM PERFORMANCE
Although each system has been fully tested prior to shipping, there will be a break-in
period. During this period, approximately 48 hours, membrane performance will
change or settle. Adjustments will need to be made to the reject flow valve, and the water
quality and quantity will vary. The reject flow valve will need to be increased (turned
clockwise) and the water quality produced will improve over this break-in period.