4.9.7 FIELD CALIBRATION
To verify the application rates in the field, follow
this procedure:
1. Fill the tank to the neck with water and mark
the level of water.
2. Check that all screens are clean.
3. Set the chemical system pressure to the
desired value and run the tractor at the
selected engine RPM in the selected gear.
4. Drive through the measured distance while
spraying.
5. Refill the tank to the same mark and measure
the amount required.
6. Divide the amount of liquid sprayed by the
area covered to determine the application
rate.
=
Appl. Rate = Volume sprayed
Area covered
gals (liters)
acre (hectare)
Table 5 Conversions
1 km .................................................. 0.62 mile
1 ha ................................................... 2.5 acres
1 g ..................................................... 0.035 oz.
1 kg ...................................................... 2.2 lbs.
1 g/ha ......................................... 0.014 oz/acre
1 kg/ha .......................................... 0.88 lb/acre
1 ml ............................................... 0.035 fl. oz.
1L .............................................. 0.264 gal (US)
1L .............................................. 0.22 gal (Imp.)
1L/s ......................................... 15.85 gpm (US)
1L/s ....................................... 13.20 gpm (lmp.)
1 kPa ................................................. 0.145 psi
1 mm .................................................... 0.04 in.
1 m ........................................................ 3.28 ft.
1 L/ha ................................ 0.106 gal (US)/acre
1 L/ha .............................. 0.088 gal (Imp.)/acre
4.9.6 AREA COVERED
To determine application rates, it is necessary to
know the area covered by the sprayer during one
pass. Table 4 gives the area for 7 widths:
Table 4 Actual Sprayer Coverage
Sprayer
Width
Acres
1/2 mile 1/4 mile
Hectares
1/2 km 1/4 km
60'
80'
88'
90'
100'
120'
132'
3.64
4.85
5.33
5.45
6.06
7.28
8.00
1.82
2.42
2.66
2.73
3.03
3.64
4.00
1.45
1.94
2.13
2.18
2.45
2.90.
3.20
0.73
0.97
1.06
1.09
1.22
1.45
1.60
32
Содержание Fast Sprayers 9500 Series
