FAST AG Solutions Fast Sprayers 9500 Series, Руководство оператора

Страница: 58 / 104

WARNING
Do not dispose of it in the farmyard or
in drainage ditches.
53
Fig. 53 CONTROL SYSTEM
41. Chemical Circuit Control
System:
Sprayers are equipped with
chemical circuit control
components that are
mounted on the trailer,
center section, and wings
as required by model.
When equipped with the
automatic circuit controller,
the valves, flow meter and
solenoids are all mounted
on the trailer, center
section, and wings.
42. Mix only the quantity of
spray required for the job.
Excess chemicals are
difficult to store and dis-
pose of. Do not dispose of
them in the farmyard or
your drainage system.
They will contaminate
these areas.
43. Store chemicals only in their original containers under lock and key to prevent children or animals from
touching them.
44. Be very careful to wear the proper protective gear such as rubber gloves and goggles to protect
yourself. Thoroughly wash all protective gear with a good detergent after use to remove all chemi-
cals.
45. Never allow chemicals or solutions to touch the skin. Some can be absorbed through the skin.
Should such a contact occur, flush the affected area immediately with clear water. Wash the area
thoroughly with detergent to remove any residue.
46. When spraying is done, the machine should always be rinsed. Follow this procedure:
a. Add 25 to 50 gallons of water to the tank.
b. Run the pump, wash circuit and agitator for 5 minutes to circulate and rinse the inside of the
tank.
c. Spray the rinse thinly over the previously sprayed field.
47. When spraying is finished for the season or when switching chemicals, wash the sprayer using the
method described in the Maintenance Section.