Farr Gold Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 42 / 76

Set the high and low-pressure drop settings using the right and left hand knobs, respectively, on the face
of the gauge. The timer will initiate pulsing of the valve solenoids when the collector pressure drop rises
to the “high” set point and continue until the collector pressure drop is lowered to the “low” set point.
Zero the photohelic gauge using the adjustment screw on the face of the gauge.
Separate box penetrations are recommended for the line power and output lines.
Note: Metal shavings
from the penetrations should be cleaned from the face of the timer board.
Establish power to the board and adjust the “ON” time, “OFF” time, number of outputs used and number
of blowdown cycles required. See programming instructions for details.
Programming Instructions
Press the “Select” button to illuminate the LED indicator adjacent to the function required, then press the
“Adjust” button to the required setting which will be displayed on the Digital Readout. After all functions
have been set, push the “Select” button to the Locked LED indicator. In the locked position, the Digital
Readout will display the last setting, which is the number of blowdown cycles programmed.
To check a specific function setting, push the “Select” button to illuminate the desired function LED, the
setting is then shown on the Digital Readout.
42
L1
GREEN
L2
SELECT
ADJUST
B2
B1
P1
P2
P3
ON TIME #OFF'S
OFF TIME LOCKED
#VALVE
1
25
2
26
3
27
4
28
5
29
6
30
7
31
8
32
9
33
10
34
11
35
12
36
13
37
14
38
15
39
16
40
17
41
18
42
19
43
20
44
21
45
22
46
23
47
24
48
INDICATORS FOR EACH OF THE 48 OUTPUTS
GOYEN SEQUENTIAL TIMER
SERIES TBD AC
17 3 2 1 7 6 5 4 12 11 10 9 8 16 15 14 13 21 20 19 18 24 23 22
41 32 27 26 25 31 30 29 28 36 35 34 33 40 39 38 37 45 44 43 42 48 47 46
L1 L2
FUSE TYPE
2AG SLW BLW
2 AMP
(-) (+)
(-)
L1 3
(+)
L2 1 2
SOLENOID
WIRING DIAGRAM
SOLENOID COILS
G P L1 120 240
L2
UPPER BLOCK LOWER BLOCK
GREEN
SIDE
RED
SIDE
RED
SIDE
GREEN
SIDE
PRESSURE TAP
CONNECTIONS
ENCLOSURE GROUND
CONNECTION
INDIVIDUAL OUTPUT
TERMINAL
COMMON OUTPUT
TERMINAL
INPUT POWER
TERMINALS
FUNCTION SELECT BUTTON
FUNCTION ADJUST BUTTON
BLOWDOWN TERMINALS
(REMOVABLE JUMPER SHOWN)
GOYEN RELAY CARD
(FACTORY WIRED)
LED FUNCTION
INDICATORS
DIGITAL READOUT
LED OUTPUT
INDICATORS
.31 IN.
Figure 400.6.1
Goyen P4 Timer