2.
44
(MT13 - En 2015)
Programming examples
Tone table
Tone of pressure of a button.
It is activated to
indicate the pressure of the buttons.
Acknowledge.
It is activated during the
programming phase to indicate a valid operation.
System ready.
Activated for 30 seconds if the
system is free
Calling.
It is activated during a call to another user
or during an intercommunicating call (active for 30
seconds or until the called user answers).
Dissuasion.
It is activated when a non-existent
device is call or when a device is not available
End conversation.
It is activated 10 seconds
before the conversation time ends
Calling table
1
DIN-DON
2
DRING1
3
DRING2
4
DRING3
5
DRING4
6
MELODY1
7
MELODY2
8
MELODY3
Note. All the acoustic signalling, with the exception
of the system ready and calling tone, last after
about 2 seconds.
Busy.
Activated on pressure of the buttons with
busy line
0
1
2
3
4
5
0
1
2
3
4
5
0
1
2
3
4
5
0
1
2
3
4
5
0
1
2
3
4
5
Monitor function.
Activated on monitor function
and confirmation of programming value
Tone.
You must pick up the handset to enter the
programming mode
Activation.
Activated on button
pressure and
numerical buttons if programmed with actuator
address
Programming.
It confirms the beginning of the
programming mode
9
MELODY4
10
MELODY5
11
MELODY6
12
MELODY7
13
MELODY8
14
BEEP
INTERNAL STATIONS
Example of manual programming of videointercom connected to 4 external door stations, intercom call in own apartment with other
3 videointercoms, intercom call with other 2
extensions and activation of actuator for supplementary services.
Note.
The example refers to an apartment with 4 videointercoms in parallel with intercom service. To allow for the individual interc
om call between videointercoms the internal station address must
be changed in the other 3 videointercoms by entering the following numbers (intercom 2 001, intercom 3 002 and intercom 4 003)
Example of system programming to enable operating mode 0 and 2 and to disable all the others operating modes
