![background image](http://html1.mh-extra.com/html/fanatec/csl-elite-pedals/csl-elite-pedals_manual_3343343036.webp)
36
6.3 Pedal auto calibration mode
First connect your ClubSport Handbrake to the ‘Handbrake’ port of your CSL
Elite Pedals LC. If you do not use a handbrake skip this step.
Then connect the CSL Elite Pedals LC to your PC or wheel base and switch ON
the connected device.
When the CSL Elite Pedals LC were powered without having done a manual
calibration yet or after a firmware update the CSL Elite Pedals LC operates in
auto calibration mode, the user can verify in PC driver, page ‘Function Test’,
see picture on right hand side
(Note: This checkbox is shown on driver
page ‘settings’ if CSL Elite Pedals LC are
connected to wheel base):
To calibrate each pedal press every pedal lever from initial mechanical position
down to 100% of pedal travel to maximum mechanical position and then back
to initial mechanical position one time.
Now the pressed pedal is calibrated automatically. The procedure for the hand-
brake (if connected) is the same.
6.4 Pedal manual calibration
If you want to make a more precise calibration of each pedal or even want to
reduce the signal array within the mechanical travel you can do so by manual
calibration.
There are two different ways to do manual calibration:
•
Manual calibration of minimum and maximum positions by PC dri-
ver:
Start PC driver application and monitor the single pedal signal indica-
tor bars. Press the pedal to the wanted mechanical minimum position,
then press the button ‘set min’ below the corresponding pedal indicator
bar in PC driver. Now the new minimum position value is stored.
NOTE:
Minimum position must be lower than maximum position, to
be achieved by shorter physical travel of pedal lever during manual cali-
bration.
Start PC driver application and monitor the single pedal indicator bars.
Press the pedal to the wanted mechanical maximum position, then
press the button ‘set max’ above the corresponding pedal indicator bar
in PC driver. Now the new maximum position value is stored.
NOTE:
Maximum position must be higher than minimum position, to