38
small force to achieve 100% brake signal
ATTENTION:
Manual calibration by driver is applicable when CSL
Elite Pedals LC is connected to PC USB port or to wheel base. Manual
calibration by wheel base is only applicable if CSL Elite Pedals LC is con-
nected to the wheel base
NOTE:
You can either check the brake signal level on the PC driver
or you can see it on the RevLEDs of the CSL Elite Wheel Base and/or the
attached Steering Wheel (depending on Steering Wheel type).
IMPORTANT:
To switch back to auto calibration mode connect the
CSL Elite Pedals LC to PC directly or to wheel base port ‘PEDAL’ and
wheel base to PC. Then open the PC driver and activate the checkbox for
‘Enable manual calibration mode, see picture on right hand side:
For further information check the FAQ section on our website
www.fanatec.com/Support
