34
WARNING
SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
14. To Change Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Classic and Falcon 90 models
Open the oven door slightly and remove the front panel
fi xing screws from the door top and bottom (A).
Carefully lift o
ff
the outer door panel.
Toledo and Professional models
Open the oven door slightly and remove the front panel
fi xing screws from the door sides (two each side).
Carefully lift o
ff
the outer door panel.
Remove door handle from panel by unscrewing 2 retaining
nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
15. To Change Main Oven Door Latch
Remove outer door panel (see 14). Remove screws ‘B’
holding latch assembly to inner door panel. Fit new catch
and reassemble in reverse order.
Check correct door operation.
14. To Adjust Main Oven Door Catch Keep
Open oven door, slacken o
ff
locknut at base of keep, and
screw in or out as required until required fi t is obtained.
Retighten locking nut.
15 To Remove Tall Oven Door
Open oven door, support the door and remove the two
screws securing the upper hinge and packing to the cooker
front. Remove the door from the lower hinge by lifting
slightly and moving outwards.
Reassemble in reverse order.
16. To Change Tall Oven Door Outer Panel
Remove oven door see 16. Lay door face down on a suitable
surface and remove 2 screws from bottom edge of door and
2 screws from inside face of door.
Remove outer door panel. Remove door handle by
unscrewing 2 screws. Remove 2 cross-headed screws
holding door handle fi xing bracket to door panel. Fit door
handle bracket and door handle to new panel.
Fit panel to door. Reassemble in reverse order.
17. To Change Tall Oven Door Magnetic Latch
Remove the control panel (see 4).
Remove the plinth (3 screws) and the central vertical cover
(5 screws). Prize the retaining clip o
ff
the magnet unit. Fit
new unit and retaining clip.
Reassemble in reverse order.
Check correct door operation.
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small hooks on
the rear face. At the corner pull seal diagonally away from
the door centre until that hook is released. Proceed to the
next hook and release it in a similar way, and so on. Use
force if the hooks are sti
ff
, as the old seal will be discarded.
When fi tting new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door,
and proceed round the door snapping in each hook in turn.
18. To Adjust Main Oven Door Catch Keep
Open oven door, slacken o
ff
locknut at base of keep, and
screw in or out as required until required fi t is obtained.
Retighten locking nut.