28
Australia
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
Adjust the height of the front roller to level the cooker. Turn
clockwise to raise the cooker and anticlockwise to lower.
When you are satisfi ed with the height and level raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the fl oor. Screw the front
roller adjuster anticlockwise to raise the front roller so that
the front of the cooker is supported on the feet, not the
front roller, to prevent accidental movement of the cooker.
Leave the levelling tool on the adjuster with the handle of
the tool facing the rear of the cooker, so that the customer
can use it if they wish to move the cooker.
Replace the drawer by locating on side runners and push in.
Fitting the splash back
(Classic model only)
The cooker can be installed with or without the supplied
splashback. To fi t the splash follow the instructions below.
view from the rear of the cooker
The splash back is fi tted using 4 screws in the rear edge
of the fl ue grille, two at each end. Remove the outer two
screws and loosen the inner pair. Fit the splash over the
inner screws and then refi t the outer two screws. (see
fi gure).
Fit the Handles
(Classic model only)
Remove the 4mm Allen screws from the doors with the
hexagon key tool. Use the screws to fi t the door handles.
The handles should be above the fi xings.
Remove the 4mm Allen screws from the top corners of the
facia and fi x the front handrail in position.
Anti-Tip Device
WARNING
An anti-Tip bracket and chain should be fi tted when the
cooker is connected to a fl exible gas supply.
Unless properly installed, the cooker could be tipped by
leaning on the door. Injury might result from spilled hot
liquids or from the cooker itself.
Kit contents
Key No
No Of
Description
1
1
Anti-Tip Bracket Base
2
1
Anti-Tip Bracket extension
3
2
M5 screw
The cooker must be set to the correct height and leveled
before the anti-tip bracket is installed.
Floor Attachment
Key No’s 1 and 2 can be assembled as shown below using
Key No. 3.
Dimension ‘A’ should be set to give a clearance of about
6 mm above the center channel of the cooker base.
