29
Australia
The assembled bracket should be fi rmly secured to the fl oor
to give a minimum engagement of 50 mm in the center
channel of the cooker base.
Wall Attachment
When fl oor attachment is impracticable and provided that
the anti-tip bracket base can be securely fi xed to a solid wall
or wall stud. Discard Key No 2.
For both fl oor and wall attachment it is essential to
use the appropriate fi xing screws and to ensure that
the Anti-Tip Bracket is fi rmly attached .
Gas Connection
The Gas sup ply needs to terminate with a down facing
bayonet. The rear cover boxes limit the position of the
supply point.
view from the back
A position for gas supply connector
B appliance gas inlet
Because the height of the cooker can be adjusted and
each connection is di
ff
erent it is di
ffi
cult to give precise
dimensions. Ideally the house supply connection should be
in the shaded area shown in the diagram. Means of isolation
must be provided at the supply point by either an approved
quick-connect device or a Type 1 manual shut-o
ff
valve.
The hose should be fi tted so that both inlet and outlet
connections are vertical so that the hose hangs downwards
in a ‘U’ shape.
The connector is located below the hotplate level at the
rear of the cooker.
A fl exible connection is supplied with the cooker. If it is
necessary to use another hose it must be to A.S. 1869 class
B and suitable for your gas type. If in doubt contact, your
supplier.
To prevent strain on the connections to the cooker the
restraining chain should be used.
Fix the supplied hook securely to the fabric of the building.
Measure the length of chain required. Use the clamp
supplied to clamp onto the gas pipe as shown.
