Falcon Haymakers, Руководство оператора

Страница: 14 / 34

Inspect all mounting pins, chains, shackles and other
load-bearing components for signs of wear. Check
that all secondary securing mechanisms such as
linchpins, split-pins and clips are in place.
Run the implement up to operating speed and
conduct visual and audible checks for excessive
vibration and noise.
Gaan alle monteerpenne, kettings, penskakels en
ander lasdraende komponente na vir tekens van
slytasie. Verseker dat alle sekondêre hegmeganismes
soos lunspenne, splitpenne en knippe in posisie is.
Versnel die implement tot werkspoed en voer visuele
en gehoorinspeksies uit vir oormatige vibrasie en
geraas.
Fig. 3 Fig. 4
Causes of excessive vibration and noise must be
identified and eliminated immediately to prevent
consequential structural or mechanical failure not
covered under warranty. Oorsake van oormatige vibrasie en geraas moet
geïdentifiseer en onmiddellik uitgeskakel word om
gevolglike strukturele of meganiese onklaarraking te
verhoed wat nie deur die waarborg gedek word nie.
AFTER each use NA elke gebruik
To be carried out at least every 40 hours in periods of
continuous use. Otherwise after each occasion that the
implement is put to use, or before long-term storage
(longer than 1 month). Word ten minste elke 40 uur in tye van deurlopende
gebruik uitgevoer. Anders na elke geleentheid wanneer die
implement gebruik is, of voor langtermynberging (langer as
1 maand).
Clean all debris from the implement, particularly the
underside of the deck. Where pressurised cleaning is
undertaken, care must be taken in areas around seals,
breathers, lubrication points and PTO driveshaft
components.
Thoroughly inspect the implement for any damages
incurred during use and note these for attention
before next use.
Ensure that all safety and warning decals are in place
and in a legible condition.
Before long-term storage (longer than 1 month),
check oil levels and thoroughly lubricate all specified
lubrication points.
Store the implement in a clean, dry, weather-
protected area.
Verwyder alle vuiligheid van die implement, veral
onder die dek. Drukspuitskoonmaak moet versigtig
gedoen word, veral naby seëls, luggate, ghriespunte
en kragaftakkeras-komponente.
Inspekteer die implement deeglik vir enige
beskadiging tydens gebruik. Merk dit aan vir aandag
en herstel voor dit weer gebruik word.
Verseker dat alle veiligheids- en waarskuwingsplakkers
in posisie, sigbaar en leesbaar is.
Voor langtermynberging moet olievlakke in die
implement nagegaan en alle ghriespunte deeglik
gesmeer word.
Stoor die implement in ‘n droë, skoon, weerbestande
plek.
PTO friction clutch inspection and adjustment Kragaftakkeras-wrywingkoppelaar-inspeksie en -verstelling
The PTO friction clutch installed on this product is a
torque-limiting device. It is an integral part of the PTO
driveshaft assembly and is intended to protect both
the implement and tractor PTO drivelines and
transmission. Die kragaftakkeras- wrywingkoppelaar is ’n wringkrag -
beperkende toestel. Dis ’n integrale deel van die
kragaftakkeras en is ontwerp om die werktuig én die
trekker se kragaftakkeras-dryfstelle en -transmissie te
beskerm.
B
A
A
12