Falcon G3840, Инструкция по установке, обслуживанию и эксплуатации

Страница: 8 / 17

8
3.9 TEMPERATURE CONTROLLERS
a) Remove control panel by undoing fixings at top and
bottom of control panel and unplug control panel.
b) Disconnect electrics loom and remove fixings to
enable controller to be removed.
c) Carefully replace in reverse order.
3.10 MAINS ON and HEAT DEMAND NEONS
a) Remove control panel by undoing fixings at top and
bottom of control panel. Disconnect control panel.
b) Remove electrical connections and undo retention nut.
c) Carefully replace in reverse order.
3.11 DRAIN VALVE
a) Remove burner as detailed in Section 3.6
b) Ensure fry pot is empty. Refer to Section 8.
c) Remove nut from handle and lift handle off.
d) Remove front panel fasteners.
e) Disconnect wiring, noting all connections.
f) Remove front panel to access drain valve.
g) Undo drain pipe. Use appropriate spanner to remove
drain valve.
h) Replace in reverse order and check for oil leaks.
3.12 FILTRATION PUMP
a) Remove back panel and flexi-hose at filtration pump.
b) Disconnect electrical coupling plug and connections
from start.
c) Remove nuts from pump mounting bolts (accessed
through fryer door at rear of oil bucket compartment)
and lift pump clear.
d) Disconnect pump from bracket.
e) Replace in reverse order.
Note: Check for oil leaks before replacing any panels.
3.13 IGNITION CONTROL BOX
a) Remove rear compartment cover.
b) Unplug valve and control plugs. Remove ignition,
detector and earth connections.
c) Undo three fixings (one at rear, two at front).
d) Remove ignition control box.
e) Replace in reverse order & test.
3.14 TEMPERATURE LIMIT THERMOSTAT
a) Open control panel.
b) Remove probe and safety thermostat protective cover
(ensuring insulation is removed intact).
c) Remove phial and probe protective cage inside pan.
d) Undo two phial bracket retention nuts and remove
thermostat phial from bracket.
e) Undo safety thermostat capillary nut. Using a thin
screwdriver - insert into boss from inside pan -
carefully tap capillary sealing washers through to
control compartment.
f) Remove thermostat.
g) Disconnect thermostat wires.
h) Carefully replace in reverse order. Check for oil leaks
and that thermostat calibration is within specification.
SECTION 4 - SPARES
When ordering spare parts, always quote unit type and
serial number. This information can be found on data
plate, located inside fryer door on LH leg support face.
Spares List
Oil bucket
Fish plate
Baskets
Splash guard / basket hanger
Control knob
Safety thermostat
Operating thermocouple
Ignition box
Pump
Pilot assembly
Valve
Fast controller
Neon
Mains cable
Switches (Pump, reset, on / off)
HT (Ignition wires)
Injectors (Kit)