Falcon FS 108Z vario, Руководство оператора

Страница: 11 / 51

Rev. Apr2 2020 ©
FALCON
Electrical Equipment
Operators Manual
11
WARNING
Do not attempt to open any boxes
containing electrical components when
power is connected to the machine. The
mains supply can cause injury or death.
Before opening the boxes containing
electrical components the mains must be
disconnected from the machine.
Repair work with 24V DC power connected
may only be performed by authorised
personnel.
3.1.01 Engaging the electrical system
The platform is equipped with a main switch,
which is located at the right side of the
platform, next to the switch for the emergency
pump.
Turn the main switch to position “ON”.
3.1.02 Choice of control
The platform can be operated from the Chassis
control panel or from the control panel in the
basket.
The key switch
(#u ) for choice of control panel
is located at the Chassis control panel (suppl.
A).
Remove the key to prevent unauthorised use of
the platform.
When the key switch
(#u ) is in position O, the
platform is turned off .
By turning the main switch to position,
or the red indicator lights on the
outriggers shall light up when the outriggers
are in stowed position or without a load.
Always check the
red indicator lights (Stability
system) at the outriggers before starting to
work.
WARNING
Do not attempt to use the platform if red
indicator lights at the outriggers are not
ON, when the outriggers are in the stowed
position or without a load.
If the
red “STABILITY” indicator lights
are out when the outriggers are lifted
from the ground, the safety system has a
malfunction.
Failure in the safety system can cause
injury or death.
Call an authorised service centre
immediately.
3.1.03 Stability system
The platform is equipped with an automatic
system by which mechanical/electrical
measurement secures that the platform always
has the minimum required stability.
If the minimum required stability is reached
the platform automatically “
CUTS OUT” the
functions that would reduce the stability further.
During minimum stability:
“
CUT OUT ” the red indicator light at the
outriggers with minimum pressure, will come
on and the indicator symbol “
MAX ” at the
Remote control panel.
If only the indicator symbol “ MAX ” at the
Basket control panel and at the Remote
control panel comes on, a secondary
“CUT
OUT” stability system is activated and notices
defl ection of the main boom.
The only functions that are free during “
CUT
OUT ” and secondary “ CUT OUT ” will be:
RETRACT TELESCOPE
MAIN BOOM UP
Z-Link up
Jib
These functions will increase the stability.