Falcon FS 108Z vario, Руководство оператора

Страница: 41 / 51

Rev. Apr2 2020 ©
FALCON
Safety Instructions
Operators Manual
41
According to the CE- and national prescriptions
only persons with the necessary instructions
may use the platform.
When the platform is used for welding work,
the platform has to be without power and the
outriggers must be placed on rubber mats.
Do not use the platform without reading and
following all instructions carefully.
Failure due to incorrect operating procedures
and safety instructions can cause injury or
death.
9.0 Safety Instructions
When using the platform you must always
make sure that the necessary stability is
maintained. The safety system (Cut out
system) secures that the maximum reachable
load according to the outreach is limited, by the
chosen positions of the outriggers.
When maximum capacity has been reached,
a
red “Stability Indicator light” comes on at the
Chassis control panel (suppl. A), at the Basket
control panel (Suppl. B) and on the outriggers
with minimum load . This indicates that the
“Cut-Out” zone has been reached.
Simultaneously, all movements that could
reduce stability further are stopped. Only
movements that will reduce the working radius
and centre the load are permitted:
“RETRACT
TELESCOPE ”, Z-link up and “MAIN BOOM
UP”.
Safe work with the platform demands that
the instructions for use and maintenance are
followed, and that the daily inspection check is
performed prior to the operation of the platform.
Check that all the labels are easily readable.
The platform must be on hard fl at ground and
level.
Work has to be stopped when wind exceeds 28
mph. (Wind force 6 after Beaufort).
When working on public roads or places,
the working area must be corded off and
surrounded by signs of fl ashing
yellow lights
according to the existing laws.
When the platform is left unattended, it must be
secured against unauthorised use.
Work near high voltage installations is
prohibited.
The platform is NOT insulated.