Fagor 8025 M CNC, Перевод оригинального руководства

Страница: 160 / 180

Remote modules.
CNC 8060
CNC 8065
7.
RCS-S-4F4
AO (SERCOS-II
PROTOCOL).
Dia
gno
sis
o
f the Sercos co
unter.
·160·
(R
EF
: 1906)
7.10.2 Updating the FeeDat and EnDat information.
If the data read on any FeeDat or EnDat encoder feedback do not match those
saved in its parameter table, the CNC displays a softkey to save the new data in
the table. The softkey is available when selecting the level of the Sercos bus. The
CNC will only display this softkey if the data read from the encoder are valid (the
encoder is connected and correctly identified) and they do not match those
already saved.
This softkey validates and saves the information read in all the FeeDat/EnDat
feedbacks whose parameters have been set in the CNC.
When the CNC is in User mode, any change in the parameter settings or the FeeDat/EnDat
configuration (for example, replacing an encoder, even with a functionally equivalent model) requires
first changing to Setup mode if you wish the changes to be permanent.
The User mode can also be used to modify the parameter settings of the feedbacks and add the new
encoder data (either from the machine parameters or from the diagnosis mode), but this change will
be temporary. When the CNC is shut down, the data are lost.