Fagor 8025 M CNC, Перевод оригинального руководства

Страница: 120 / 180

Remote modules.
CNC 8060
CNC 8065
6.
RIOR REMOTE MODULES.
(CANOPEN
PROTOCOL).
De
scri
pti
on of
co
nne
ctors.
·120·
(R
EF
: 1906)
·D46· ERR led, transmission status indicator.
·I44A·/·I44B· Digital inputs and outputs.
See "6.6 Connection of the digital inputs and outputs." on page 124.
Red LED. Its meaning depends on the blinking speed.
Blinking rate. Description.
Off. The module is ready to run.
Intermittent. Module configuration stage.
Single blinking. Poor transmission. At least one of the error
counters of the CAN controller has reached the
alarm level.
Double blinking. There is no communication with the cpu.
On Error. The CAN controller is in "Bus Off" state.
D46
D45
50-pin male IDC connector with a latch. Use a female
connector for ribbon cable. Maximum height of the connector,
14.5 mm.
• Connector ·I44A·.
• Connector ·I44B·.
Pin. Signal. Description.
1 GND 0 V reference signal.
2 24V_OUT 24 V output for digital inputs.
3···26 I1 - I24 Digital inputs.
27···30 - - -
31···46 O1 - O16 Digital outputs.
47···50 24V 24 V supply for digital outputs.
Pin. Signal. Description.
1 GND 0 V reference signal.
2 24V_OUT 24 V output for digital inputs.
3···26 I25 - I48 Digital inputs.
27···30 - - -
31···46 O17 - O32 Digital outputs.
47···50 24V 24 V supply for digital outputs.
2 1
50
pi
ns
14.5 mm