Fagor 8025 M CNC, Перевод оригинального руководства

Страница: 119 / 180

Remote modules.
CNC 8060
CNC 8065
RIOR REMOTE MODULES.
(CANOPEN
PROTOCOL).
6.
De
scri
pti
on of
co
nne
ctors.
·119·
(R
EF
: 1906)
·A22· 24 V DC supply input.
·B28A·/·B28B· CAN bus.
·D45· RUN led, module status indicator.
Connector data.
Number of poles. 3.
Pitch. 7.62 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.5 / 0.6 Nm.
Minimum/maximum section.
0.2 / 2.5 mm².
Rated current In. 12 A.
Cable data.
Length to be stripped. 7 mm.
See "6.2 Powering the modules." on page 115.
Connector data.
Number of poles. 5.
Pitch. 3.5 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.22 / 0.25 Nm.
Minimum/maximum section.
0.14 / 1.5 mm².
Rated current In. 8 A.
Cable data.
Length to be stripped. 7 mm.
See "6.5 CAN bus connection." on page 123.
Plug-in part 3-pole Phoenix combicom contact (7.62 mm pitch). Rated
current; 12 A.
Pin Signal. Function.
1 - - -.
2 GND 0 V reference signal.
3 +24 V Power supply.
Plug-in part 5-pole Phoenix contact minicombicon connector (3.5 mm
pitch). Rated current; 8 A.
Pin. Signal. Function.
1 GND Ground / 0 V.
2 CL (LOW) bus signal.
3 SH CAN shield.
4 CH (HIGH) bus signal.
5 SH CAN shield.
The LED is green. Its meaning depends on the blinking speed.
Blinking rate. Description.
Intermittent. Module in PRE-OPERATIONAL state.
Single blinking. Module in STOPPED state.
On. Module in OPERATIONAL state.
D46
D45