Fagor 8025 M CNC, Перевод оригинального руководства

Страница: 146 / 180

Remote modules.
CNC 8060
CNC 8065
7.
RCS-S-4F4
AO (SERCOS-II
PROTOCOL).
Mo
dule
co
nfi
guratio
n on th
e CNC.
·146·
(R
EF
: 1906)
7.8 Module configuration on the CNC.
7.8.1 Module identification at the bus
The SCR-S module is, like the drives, a node type of the Sercos ring. In terms of parameter
setting, these modules have dual identification, physical and logic, as described next.
Physical module identification.
Each counter must be identified by a number (Sercos ID) using the thumbwheel located on
its front plate. That identifier must be unique in the ring, the number is sequential from 1 to
n and without skipping any and "n" being the total number of Sercos nodes (including drives
and counters).
Logic module identification.
The SERCOUNTID table of the general machine parameters allows linking the logic number
of the Sercos counters (1..8) to the physical number set by the thumbwheel of each node
(enter in each position of the Sercos ID table associated with that logic position of the
counter).
Identifying the feedback inputs and analog outputs on the
modules.
Remote Sercos type feedback inputs (COUNTERID) and analog outputs (ANAOUTID) that
may be used when setting the parameters of axes or handwheels follow the allocation criteria
based on the logic numbering of the Sercos counters. The physical numbering set by the
Sercos ID is irrelevant.
• SERCOUNTID1 COUNTERID (1..4) ANAOUTID (1..4)
• SERCOUNTID2 COUNTERID (5..8) ANAOUTID (5..8)
... ... ...
• SERCOUNTID8 COUNTERID (29..32) ANAOUTID (29..32)