Fagor 8025 GP, Руководство по эксплуатации

Страница: 6 / 423

- 6 -
4. SPINDLE FOLLOWING ERROR DISPLAY WHILE IN M19
From this version on, when operating with spindle orient (M19), the CNC also shows the spindle following error on the
screen corresponding to the following error in Automatic and Single block modes.
The Following Error screen shows, in large characters, the amount of axis lag and, under it, the following information
line.
F 00000.0000 & 100 S 0000 % 100 T 00.00 S 0000.000
The last value of this line "S 0000.000" shows the amount of following error (lag) of the spindle when it operates in
spindle orient mode (M19).
5. GANTRY AXES NOT MECHANICALLY SLAVED
From this version on, depending on the setting of machine parameter "P629(8)", it is possible to work with two different
types of Gantry axes.
"P629(8)=0" Mechanically slaved Gantry Axes. As until now.
When being homed, both axes behave as a single axis. The CNC takes into account only the parameter
settings and feedback pulses of the main axis, the slaved one being just a follower of the main axis,
"P629(8)=1" Not-mechanically slaved Gantry axes.
When being homed, the two axes behave as separate independent axes. First the main axis is homed
and, then, the slaved one.
6. SHEETMETAL FORMING MACHINES
This feature is available on GP models.
To enable it, set machine parameter "P626(7)=1". The CNC enables functions M98 and M99 to control the X axis
positioning loop.
Function M98 opens the X axis loop and M99 closes it.
When the CNC executes an M30, it also closes the X axis positioning loop.
When operating in jog mode, the CNC enables he following keys to control the X axis positioning loop:
Executes an M98 opening the X axis loop.
Executes an M98 opening the X axis loop.
Executes an M98 closing the X axis loop.
Version 7.2 (April 1997)
1. SCREEN SAVER
The screen saver function works as follows:
After 5 minutes without pressing a key or without the CNC refreshing the screen, the screen goes blank. Press any
key to restore the display.
Machine parameter "P626(5)" indicates whether this feature is to be used or not.
P626(5) = 0This feature is not being used.
P626(5) = 1This feature is being used.
2. JOGGING FEEDRATE
If while in JOG mode, the conditional input (block skip), pin 18 of connector I/O1, the CNC does not allow entering a
new F value. Only the feedrate override (%) may be varied by means of the MFO switch.