Fagor 8025 GP, Руководство по эксплуатации

Страница: 413 / 423

Section: Chapter: 3
Page
2
NON-SERVO CONTROLLED
OPEN LOOP MOTORS
CONNECTOR I/O 1
Pin SIGNAL AND FUNCTION
1 0V. Input from external power supply
2 T Strobe Output. The BCD outputs refer to a tool code.
3 S Strobe Output. The BCD outputs refer to an "S" code (spindle).
4 M Strobe Output. The BCD outputs refer to an "M" code.
5 Emergency Output
6 W axis Brake Output
7 Z axis Brake Output
8 Y axis Brake Output
9 X axis Brake Output
10 Home switch (X) Input from X axis home switch.
11 Home switch (Y) Input from Y axis home switch.
12 Home switch (Z) Input from Z axis home switch.
13 Home switch (W) Input from W axis home switch.
14 Emergency Stop Input
15 Feed Hold Input
Transfer inhibit
M done
16 Cycle Stop Input
Emergency Subroutine
17 Cycle Start Input
Rapid feed
Enter in Play-back mode
18 Block Skip Conditional input
19 DRO Input. The CNC acts as a DRO.
20 MST80 BCD coded output, weight: 80
21 MST40 BCD coded output, weight: 40
22 MST20 BCD coded output, weight: 20
23 MST10 BCD coded output, weight: 10
24 MST08 BCD coded output, weight: 8
25 MST04 BCD coded output, weight: 4
26 MST02 BCD coded output, weight: 2
27 MST01 BCD coded output, weight: 1
28 CHASSIS Connect all cable shields to this pin.
29 24V. Input from external power supply.
30 Not being used at this time.
31 Not being used at this time.
32 Not being used at this time.
33 Not being used at this time.
34 Not being used at this time.
35 Not being used at this time.
36 Not being used at this time.
37 Not being used at this time.
INTRODUCTION