Fagerhult e-Sense Organic G3, Руководство пользователя

Страница: 13 / 31

13
Subject to change without notice. Version5_20200424
Use + and - in the Light Output tab to adjust the light level. Adjust all lumin -
aires that use this function. Use + and - to adjust the entire zone in order for
all luminaires to have the same level.
1. Point the dongle at a luminaire and press the Calibrate and Enable but-
ton.
2. Using the Relay button you can now initiate the process to adjust all
nodes and read the desired light level.
3. Finish with Save Settings and Relay.
With Enable and Disable you can start/stop the function.
NOTE! Do not stand underneath a sensor when it is in calibration mode. It
is also advisable to have the right furniture in place, so that the setting does
not apply to the floor, but rather the work area.
You can easily simulate the function of a touch panel from the Simulated
Wall Switch tab. It gives an idea of the functions offered by the panel.
Setting Daylight Dimming
Simulated Wall Switch
Daylight dimming is an effective way to optimise energy saving. For example, luminaires at windows in a large office can dim
according to incident daylight. Luminaires farther into a room can be optimised by selecting the correct fixed light level. If
luminaires that will use daylight dimming are in a separate zone, it is easier and quicker to make adjustments that apply to
all. It’s important that daylight dimming is adjusted when the effect of sunlight is not dominant, preferably below 5% of the
amount of light measured with a lux meter. Adjusting the “Max Light” must be carried out before, since this level is the basis
for the target value which the system will attempt to maintain. If the luminaires are able to provide approx. 700 lux without
being affected by daylight, the level can be adjusted down to just over 500 lux, which is the recommended value for offices
and workspaces.
Daylight Dimming
1 2
3